50pcs/Lot Traffic Inductive Loop Vehicle Detector Signal Control 110V AC
Warning: Last items in stock!
Vehicle Loop Detector:
The detector must be installed in a convenient weatherproof location as close to the loop as possible. Installation location must choose to stay away from the heat source; it around other devices must maintain a distance of at least 10mm (must not installation close with boxes wall). A correct loop configuration and detector installation will ensure a successful inductive loop detection system. Loop of several important parameters include: loop figure, size, turns, install methods.
Operation and Indication
While the detector is tuning, the green Channel LED and red Power LED will be turn on. It remain about 2 seconds, then the green LED turn off. If a loop fault exists the Channel LED will come on and flash indicating a fault. If the fault is self-healing the detector will continue to operate. The green channel LED will also glow whenever a vehicle is detected passing over the inductive loop. The red Power LED at the top of the unit will remain on to indicate that the unit is powered.
Supply voltage: 230VAC , 115V AC, 24V DC/AC, 12V DC/AC ( Seethe label on the detector)
Voltage tolerance AC: +10% / -15%
Voltage tolerance DC: 15%
Power Consumption: 4.5VA
Output relays: 240V/5A
Operating temperature: -20C to +65C
Cheap detector gsm, Buy Quality control breathing directly from China detector smoke Suppliers: 50pcs/Lot Traffic Inductive Loop Vehicle Detector Signal Control 110V AC
|Type||Automatic Car Bumper|
|name||Signal Control loop detector|
|Unit Type||lot (50 pieces/lot)|
|Package Weight||9.0kg (19.84lb.)|
|Package Size||14cm x 14cm x 7cm (5.51in x 5.51in x 2.76in)|